Rebuild Procedure                                   

• Dismantle machine (R4 example)
• Inspect casting and worn parts
• Notify customer of findings

• Chrome plate Crank shaft for longer wear
• Chrome plate bottom plunger
• Use superior Bronze material on all bearings
• (mains,bottom plunger,bottom pressure fork,ejection,guide rod,eccentric,yoke,roller,pulley)
• Grind table linner and shim to spec.
• Align machine
• Grind ejection and bottom pressure wear pads
• New pin for ejection fork
• New ejection shaft,pin,roller
• New shaft and pins for bottom pressure
• New guide rod
• New pin for saddle (yoke)
• New roller pin
• New die clamp ring
• Reface ejection and bottom pressure lift nuts
• Dismantle clutch replace parts needed
• Paint Machine

• Assemble press
• Lubricate machine
• Run machine 4 hours
• Ship